tutorials:introduction

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
tutorials:introduction [2022/06/23 13:51] thomastutorials:introduction [2022/06/23 13:52] (current) thomas
Line 22: Line 22:
   * Double-click on any entry in the folder inside ''Optimization Results''   * Double-click on any entry in the folder inside ''Optimization Results''
  
-The simulation will now re-run for that specific set of [[doc:parameters|parameters], and the result can be viewed in the Viewer panel on the right. Once the simulation is done, you can analyze the motion using the playback controls "Viewer" tab (see below). Initially, the results won't be very impressive, but they'll get better as the optimization progresses. At any time, you can double-click any new entry in the Optimization Results.+The simulation will now re-run for that specific set of [[doc:parameters|parameters]], and the result can be viewed in the Viewer panel on the right. Once the simulation is done, you can analyze the motion using the playback controls "Viewer" tab (see below). Initially, the results won't be very impressive, but they'll get better as the optimization progresses. At any time, you can double-click any new entry in the Optimization Results.
  
 At any time, it is possible to abort an optimization; either through the menu or by pressing the 'x' in the top right corner of the progress window. Optimizations will also terminate when [[doc:optimizer|specific conditions]] are met. At any time, it is possible to abort an optimization; either through the menu or by pressing the 'x' in the top right corner of the progress window. Optimizations will also terminate when [[doc:optimizer|specific conditions]] are met.